What is geofencing? Explanation and uses for construction sites and machine fleets.
Your thermostat starting to heat up as you drive home. A camera that switches on when you leave. That's geofencing. For anyone managing machines and vehicles, it's mainly a way to know automatically what happens where.
What is geofencing?.
Geofencing means drawing a virtual boundary, a "geofence", around an area on the map. A system then notices when a device with a GPS position, such as a smartphone or a tracker on a machine, enters the area, leaves it or stays in it.
How does it work?.
- You draw a zone: a circle around a point, or a polygon around a site.
- The device sends its position.
- The system compares that position with the zone, so it can count, report or send a signal per zone.
- How precise it is depends on the GPS (usually a few metres) and how often the position comes in.
Four uses for sites and machines.
- Hours per site. Which machines ran on a project, and for how long. You need this for job costing, but also for a CO₂ project dossier or the share of zero-emission work in a Dutch SEB tender.
- Rental invoicing. How many hours a machine was at your client's location.
- Depot and returns. Which machines are back at the depot, and which are still on a site.
- Signals outside working hours. A machine leaving its zone outside working hours can point to theft. Many systems can send an alert for that.
What to watch out for.
- Don't draw a zone too tight. Because of GPS inaccuracy, a machine near the edge may fall in or out of the zone.
- Keep your zones up to date: a new site is a new zone, and a finished site gets closed.
- Use fixed names, so you can find reports per site or client.
- For vehicles with a regular driver: inform your employees beforehand about the use of location data.
Geofencing in monytr.
In monytr you draw a zone around a site, a depot or a client location. Pick a period and you get one report of every machine that ran there, and for how long.